Love to ride?
Very light and ultra stiff race bike! This bike is based on the ultralight and super stiff carbon race frame which was victorious in Paris-Roubaix three times although being the lightest frame in that race. The R3 is much more than just a Paris-Roubaix bike. Its low weight and high stiffness also make it ideal for climbers and even sprinters. The R3 represents the latest in bicycle design, comfort and efficiency. Equipped with Shimano Ultegra components for a perfect price-value-ratio. The R3 has gotten a tapered headtube, a new tube shape for higher torsional stiffness and the BBright system which is an oversized bottom bracket. The BB shell is 79 mm wide with internal press-in bearings. This increases bottom bracket stiffness. Cervelo says that in-house testing revealed definite advantages with a tapered front end but that the commonly accepted 1-1/8" to 1 1/2" standard was actually too rigid. Cervelo ultimately settled on a 'sweet spot' of 1 3/8", using a new lower headset standard. The matching all-carbon fork is still light but noticeably stiffer with more precise handling. In addition, the lower bearing seat is molded directly into the fork crown, thus eliminating a redundant part and also lending a straighter path for the carbon fibers in that area. Squoval down tube and chain stays - optimized for the highest possible stiffness-to-weight ratio (STW), the down tube and chain stays have a "squoval" shape. Lay-up optimization - the stiffening plies are added to the sides of the tubes where they have the greatest effect in bending. They are feathered to distribute the loads into the structure. Cervelo also added more plies on the bottom of the down tube, the head tube and the top tube to distribute the loads from a potential head tube impact. Finally, Cervelo added Kevlar to that same area and down tube to prevent catastrophic failure. Razor-thin seatstays - the original Cervelo R3 was the first frame ever to incorporate ultra-thin seatstays. The new R3 series frames feature even smaller seatstay cross sections than before, further increasing the already legendary compliance for the rear wheel. The seat stays are almost unnecessary for the vertical loads, they only provide torsional stiffness. Therefore, Cervelo was able to design the R3 seat stays to act as leaf springs in the vertical plane while having a more standard dimension in the lateral plane for torsional rigidity. Thus it combines strength, comfort, torsional stiffness and minimal weight.